Click here

СИСТЕМА SFI, Diagnostic DTC:P0604, P0606, P060A, P060B, P060D, P060E, P0657, P1607

Click here
Click here
DTC Code DTC Name
P0604 Internal Control Module Random Access Memory (RAM) Error
P0606 ECM / PCM Processor
P060A Internal Control Module Monitoring Processor Performance
P060B Internal Control Module A/D Processing Performance
P060D Internal Control Module Accelerator Pedal Position Performance
P060E Internal Control Module Throttle Position Performance
P0657 Actuator Supply Voltage Circuit / Open
P1607 Cruise Control Input Processor
Click here

DESCRIPTION

The ECM continuously monitors its own internal memory status, internal circuits and output signals transmitted to the throttle actuator. This self-check insures that the ECM is functioning properly. If any malfunction is detected, the ECM sets the appropriate DTC and illuminates the MIL.

The ECM memory status is diagnosed by internal mirroring of the main CPU and sub CPU to detect Random Access Memory (RAM) errors. The two CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and sets a DTC if: 1) outputs from the two CPUs are different or deviate from the standard, 2) the signals sent to the throttle actuator deviate from the standard, 3) a malfunction is found in the throttle actuator supply voltage, or 4) any other ECM malfunction is found.

DTC No. DTC Detection Condition Trouble Area

P0604

P0606

P060A

P060B

P060D

P060E

P0657

P1607

 ECM internal error (1 trip detection logic) ECM
Click here

INSPECTION PROCEDURE

Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

Click here

PROCEDURE


  1. Click here

    CHECK DTC


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG) and turn the tester ON.

    3. Clear the DTCs (Click here).

    4. Turn the engine switch off and turn the tester off.

    5. Disconnect the tester.

    6. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    7. Connect the cable to the negative (-) battery terminal.

    8. Connect the tester to the DLC3.

    9. Turn the engine switch on (IG) and turn the tester ON.

    10. Enter the following menus: Powertrain / Engine / DTC.

    11. Read the DTCs.

      Result
      Result Proceed to
      DTCs P0604, P0606, P060A, P060B, P060D, P060E, P0657 and/or P1607 is output A
      DTC is not output B
      DTC P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C and P033D are output C

  2. Click here

    CHECK FOR INTERMITTENT PROBLEMSClick here

  3. Click here

    REPLACE ECMClick here

  4. Click here

    GO TO DTC (P0327, P0328, P032C, P032D, P0332, P0333, P033C and P033D)Click here