СИСТЕМА SFI, Diagnostic DTC:P1366, P1367

DTC Code DTC Name
P1366 "E" Camshaft Position Actuator Circuit Open, Low, High Bank1
P1367 "E" Camshaft Position Actuator Circuit Open, Low, High Bank2

DESCRIPTION

Refer to DTC P0010 Click here.

DTC No. DTC Detection Condition Trouble Area
P1366

Malfunction in diagnostic signal (VTM1) of camshaft timing control motor is detected for 3 seconds

(1 trip detection logic)

  • Camshaft timing control motor (bank 1)

  • Wire harness and connector
P1367

Malfunction in diagnostic signal (VTM2) of camshaft timing control motor is detected for 3 seconds

(1 trip detection logic)

  • Camshaft timing control motor (bank 2)

  • Wire harness and connector

MONITOR DESCRIPTION

This DTC is output when a diagnostic signal malfunction is detected in the intake side camshaft timing control motor. The camshaft timing control motor is equipped with a self diagnostic function, which is used to output the condition of the camshaft timing control motor as a diagnosis signal (VTM) to the ECM. If the ECM receives a diagnosis signal that is not one of the set signals, a DTC is output immediately (1 trip detection logic).

If the engine is idled for 10 seconds, a DTC is detected.

WIRING DIAGRAM

Refer to DTC P1360 Click here.

INSPECTION PROCEDURE

Tech Tips

Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (CAMSHAFT TIMING CONTROL MOTOR - ECM)


    1. A01GLR2E36

      Disconnect the E10 or E18 camshaft timing control motor connector.

    2. Disconnect the E4 or E2 ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance (Check for open)
      Tester Connection Condition Specified Condition
      E10-1 (VTM1) - E4-9 (EMD1) Always Below 1 Ω
      E18-1 (VTM2) - E2-31 (EMD2)
      Standard resistance (Check for short)
      Tester Connection Condition Specified Condition
      E10-1 (VTM1) or E4-9 (EMD1) - Body ground Always 10 kΩ or higher
      E18-1 (VTM2) or E2-31 (EMD2) - Body ground

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. REPLACE CAMSHAFT TIMING CONTROL MOTOR (BANK 1 OR BANK 2)


    1. Replace the camshaft timing control motor Click here.


    NEXT

  3. CHECK WHETHER DTC OUTPUT RECURS


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the tester ON.

    4. Clear the DTCs Click here.

    5. Start the engine and allow the engine idle for 10 seconds or more.

    6. Enter the following menus: Powertrain / Engine / DTC.

    7. Read DTCs.

      Result
      Display (DTC Output) Proceed to
      No DTC A
      Other DTCs B

    B

    GO TO DTC CHART Click here

    A

    END