Click here

CAN COMMUNICATION SYSTEM (for RHD) Combination Meter ECU Communication Stop Mode

Click here
Click here Click here
DTC Code DTC Name
  Combination Meter ECU Communication Stop Mode
Click here

DESCRIPTION

Detection Item Symptoms Trouble Area
Combination Meter ECU Communication Stop Mode

Either condition is met:


  • "Combination Meter" is not displayed on "Bus Check".

  • "Combination Meter ECU Communication Stop Mode" in "DTC Combination Table" applies.

  • Power source or inside of No. 1 meter ECU sub-assembly

  • No. 1 meter ECU sub-assembly CAN branch wire or connector

  • No. 1 meter ECU sub-assembly
Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Tip:

Operating the power switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work (Click here).


  2. Click here

    DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Disconnect the cable from the negative (-) auxiliary battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      Note:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


  3. Click here

    CHECK FOR OPEN IN CAN BUS WIRE (NO. 1 METER ECU SUB-ASSEMBLY CAN BRANCH WIRE)


    1. A01H1Q1E04

      Disconnect the No. 1 meter ECU sub-assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      L124-20 (CANH) - L124-21 (CANL) Power switch off 54 to 69 Ω
      Table 1. Text in Illustration
      *a

      Front view of wire harness connector

      (to No. 1 Meter ECU Sub-assembly)

  4. Click here

    CHECK HARNESS AND CONNECTOR (NO. 1 METER ECU SUB-ASSEMBLY - BATTERY AND BODY GROUND)


    1. A01H1Q1E05

      Connect the cable to the negative (-) auxiliary battery terminal.

      Note:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      L124-13 (B) - Body ground Always 11 to 14 V
      L124-14 (IG2) - Body ground Power switch on (IG) 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L124-18 (ES) - Body ground Always Below 1 Ω
      Table 2. Text in Illustration
      *a

      Front view of wire harness connector

      (to No. 1 Meter ECU Sub-assembly)

  5. Click here

    REPAIR OR REPLACE NO. 1 METER ECU SUB-ASSEMBLY CAN BRANCH WIRE OR CONNECTOR (CANH, CANL)

  6. Click here

    REPLACE NO. 1 METER ECU SUB-ASSEMBLYClick here

  7. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR