Click here

CAN COMMUNICATION SYSTEM (for RHD), Diagnostic DTC:U1111

Click here
Click here Click here
DTC Code DTC Name
U1111 Lost Communication with Body No. 5 Module
Click here

DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
U1111 There is no communication from the front multiplex network light ECU (front controller).

  • Power source or inside of front multiplex network light ECU (front controller)

  • Front multiplex network light ECU (front controller)
Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (FRONT CONTROLLER - BATTERY AND BODY GROUND)


    1. A01GY18E01

      Disconnect the front multiplex network light ECU (front controller) connectors.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A50-1 (FMB3) - Body ground Always 11 to 14 V
      A52-1 (BATB) - Body ground Always 11 to 14 V
      A52-5 (ALTB) - Body ground Always 11 to 14 V
      A50-5 (FMIG) - Body ground Power switch on (IG) 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A50-2 (E) - Body ground Always Below 1 Ω
      Table 1. Text in Illustration
      *a

      Front view of wire harness connector

      (to Front Multiplex Network Light ECU [Front Controller])

  2. Click here

    REPLACE FRONT MULTIPLEX NETWORK LIGHT ECU (FRONT CONTROLLER)

  3. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR