Click here

CAN COMMUNICATION SYSTEM (for LHD) Hybrid Vehicle Control ECU Communication Stop Mode

Click here
Click here Click here
DTC Code DTC Name
  Hybrid Vehicle Control ECU Communication Stop Mode
Click here

DESCRIPTION

Detection Item Symptom Trouble Area
Hybrid Vehicle Control ECU Communication Stop Mode

Either condition is met:


  • "Hybrid Vehicle Control" is not displayed on the "Bus Check" screen.

  • "Hybrid Vehicle Control ECU Communication Stop Mode" in "DTC Communication Table" applies.

  • Power source or inside of hybrid vehicle control ECU

  • Hybrid vehicle control ECU
Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - BATTERY AND BODY GROUND)


    1. A01GXG3E09

      Disconnect the hybrid vehicle control ECU connectors.

      Table 1. Text in Illustration
      *a

      Rear view of wire harness connector

      (to Hybrid Vehicle Control ECU)

      		 - -

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      A76-1 (BATT) - Body ground Always 11 to 14 V
      A76-4 (IGSW) - Body ground Power switch on (IG) 11 to 14 V
      A78-1 (+B1) - Body ground Power switch on (IG) 11 to 14 V
      A78-2 (+B2) - Body ground Power switch on (IG) 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A77-7 (E1) - Body ground Always Below 1 Ω
      A77-6 (E12) - Body ground Always Below 1 Ω
      E58-7 (GND1) - Body ground Always Below 1 Ω
      E58-6 (GND2) - Body ground Always Below 1 Ω

  2. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  3. Click here

    REPLACE HYBRID VEHICLE CONTROL ECUClick here