REAR SUNSHADE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows the values or states of switches, sensor, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus:

      Select: Body / (desired system) / Data List.

    5. According to the display on intelligent tester, read the "Data List".

      Center Console Switch
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Rear Shade Switch Rear sunshade switch/ON or OFF

      ON: Rear sunshade switch is pressed

      OFF: Rear sunshade switch is not pressed

      		 -
      Rear Console Switch
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Rear Shade Switch Rear sunshade switch/ON or OFF

      ON: Rear sunshade switch is pressed

      OFF: Rear sunshade switch is not pressed

      		 -
      Body No. 4
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Rear Sunshade Close Status of the rear sunshade close/YES or NO

      YES: Rear sunshade limit switch is OFF (Rear sunshade is lowered)

      NO: Rear sunshade limit switch is ON (Rear sunshade is raised)

      		 -

  2. ACTIVE TEST

    Tech Tips

    Using the intelligent tester to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    Note

    When a Body No. 4 (luggage room junction block) related vehicle switch is ON, Active Test items related to the vehicle switch are prohibited (double operation prohibition). Check that the vehicle switches are OFF before performing Active Tests.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus:

      Select: Body / Body No. 4 / Active Test.

    5. According to the display on intelligent tester, perform the "Active Test".

      Body No. 4
      Tester Display Test Part Control Range Diagnostic Note
      Rear Sunshade Operation Rear Sunshade Operation Down, No or Up -