ROCKER PANEL MOULDING REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH


    1. A01GZ7EE01
      Text in Illustration
      *1 Protective Tape
      *2 Wooden Block

      Put protective tape around the front fender moulding.

    2. Insert a piano wire between the vehicle body and front fender moulding sub-assembly LH.

    3. Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.

    4. Pull the piano wire and scrape off the double-sided tape that holds the front fender moulding sub-assembly LH to the vehicle body.

    5. A01H07AE01
      Text in Illustration
      *1 Double-sided Tape

      Detach the clip and guide and remove the front fender moulding sub-assembly LH.

      Note

      Be careful not to damage the vehicle body.

  2. REMOVE FRONT FENDER WHEEL OPENING MOULDING LH

    A01H219

    1. Remove the 5 screws.

    2. Detach the clip and remove the moulding.

  3. REMOVE QUARTER PANEL WHEEL OPENING MOULDING LH

    A01GWCE

    1. Remove the 4 screws and moulding.

  4. REMOVE NO. 6 ROCKER PANEL MOULDING PROTECTOR


    1. A01GY5U

      Using a clip remover, remove the clip.

    2. Remove the 2 screws and No. 6 rocker panel moulding protector.

  5. REMOVE FRONT DOOR NO. 3 WEATHERSTRIP LH


    1. Fully open the front door and rear door.

    2. for Standard Body:

      Detach the 12 clips and remove the front door No. 3 weatherstrip LH.

    3. for Long Body:

      Detach the 13 clips and remove the front door No. 3 weatherstrip LH.

      A01GW7OE01
      Text in Illustration
      *A for Standard Body *B for Long Body

  6. REMOVE ROCKER PANEL MOULDING LH


    1. A01GXNI

      Remove the screw on the front side.

    2. A01GZQD

      Remove the screw on the rear side.

    3. for Standard Body:

      Using a clip remover, remove the 7 clips.

    4. for Long Body:

      Using a clip remover, remove the 8 clips.

      A01H0V5E01
      Text in Illustration
      *A for Standard Body *B for Long Body
    5. A01H1WA

      Remove the 2 screws.

    6. Put protective tape around the rocker panel moulding LH.

    7. for Standard Body:

      Detach the 10 clips and remove the rocker panel moulding LH.

    8. for Long Body:

      Detach the 11 clips and remove the rocker panel moulding LH.

      A01GYM5E01
      Text in Illustration
      *A for Standard Body *B for Long Body
      *1 Protective Tape - -