LUGGAGE COMPARTMENT DOOR OPENER MAIN SWITCH INSTALLATION


  1. INSTALL LUGGAGE DOOR OPENING CANCEL SWITCH ASSEMBLY


    1. A01H1VL

      Attach the 2 claws and install the luggage door opening cancel switch assembly.

  2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    1. Connect each connector and attach each wire harness clamp.

    2. Install the glove compartment door assembly with the 5 screws <C>.

  3. INSTALL NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY LOWER


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A01GYLT

      Push in the lock to connect the airbag connector.

    4. Connect the airbag connector to the front passenger side knee airbag assembly

      Note

      When connecting airbag connector, take care not to damage the airbag wire harness.

    5. Attach the claw to install the front passenger side knee airbag assembly.

    6. Install the 3 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the front passenger side knee airbag assembly is installed securely without any excessive gaps and is not protruding outward.

  4. INSTALL INSTRUMENT PANEL LOWER


    1. Attach the 2 claws and clip to install the lower instrument panel.

  5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01GXKN

    1. Connect the connector.

    2. Insert the 2 guides.

    3. Attach the 4 claws to install the No. 2 instrument panel under cover sub-assembly.

  6. INSTALL INSTRUMENT SIDE PANEL RH

    A01GZC3

    1. Attach the 6 clips to install the instrument side panel RH.

  7. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Tech Tips

    Use the same procedure described for the LH side.

  8. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSTALL BATTERY SERVICE HOLE COVER LH


    1. A01GZIME02
      Text in Illustration
      *A for Standard
      *B for Ottoman

      Attach the battery service hole cover LH with the clip and fastening tape.

  10. INSTALL DECK TRIM SIDE BOARD LH


    1. A01GXQQ

      Attach the 2 clips to install the deck trim side board LH.

  11. INSTALL DECK BOARD ASSEMBLY

    A01GZ3P

  12. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    A01GWKI

  13. CHECK SRS WARNING LIGHT

    Click here