LUGGAGE COMPARTMENT DOOR OPENER MAIN SWITCH REMOVAL


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    A01GWKI

  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    A01GZ3P

  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)


    1. A01GXQQ

      Detach the 2 clips and remove the deck trim side board LH.

  5. REMOVE BATTERY SERVICE HOLE COVER LH


    1. A01GZIME02
      Text in Illustration
      *A for Standard
      *B for Ottoman
      *1 Fastening Tape

      Detach the clip, fastening tape and remove the battery service hole cover LH.

  6. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    Tech Tips

    Use the same procedure described for the LH side.

  8. REMOVE INSTRUMENT SIDE PANEL RH

    A01GXU2E01
    Text in Illustration
    *1 Protective Tape

    1. Apply protective tape as shown in the illustration.

    2. Using moulding remover D, detach the 6 clips and remove the instrument side panel RH.

  9. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01GYHQ

    1. Detach the 4 claws and remove the No. 2 instrument panel under cover sub-assembly.

    2. Disconnect the connector.

  10. REMOVE INSTRUMENT PANEL LOWER


    1. A01H1VJE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the lower instrument panel.

    2. Using a screwdriver, detach the clip and 2 claws to remove the lower instrument panel.

  11. REMOVE NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY LOWER


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A01H07R

      Remove the 3 bolts.

    4. Detach the claw to remove the front passenger side knee airbag assembly.

    5. Using a screwdriver release the airbag connector lock.

    6. Using a screwdriver, disconnect the airbag connector.

      Note

      When disconnecting airbag connector, take care not to damage the airbag wire harness.

  12. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    A01GY3I

    1. Remove the 5 screws <C> and glove compartment door assembly.

    2. Disconnect each connector and detach each wire harness clamp.

  13. REMOVE LUGGAGE DOOR OPENING CANCEL SWITCH ASSEMBLY


    1. A01H1VL

      Detach the 2 claws and remove the luggage door opening cancel switch assembly.