FRONT DOOR ADJUSTMENT

A01GXZXE01

Tech Tips


  • Before adjusting the door position for vehicles equipped with side airbags and curtain shield airbags, be sure to disconnect the battery. After adjustment, inspect the SRS warning light, the side airbag system and the curtain shield airbag system for normal operation.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

Text in Illustration
*1 Centering Bolt
*2 Standard Bolt

  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. ADJUST FRONT DOOR


    1. Disconnect the cable from the auxiliary battery negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    2. A01GZNK

      Using SST, loosen the body's hinge bolts and adjust the door's position.

      SST
      09812-00010

    3. Using SST, tighten the body's hinge bolts after the adjustment.

      Torque:
      32.5 N*m  { 332 kgf*cm, 24 ft.*lbf }

    4. Loosen the door's hinge bolts and adjust the door's position.

    5. Tighten the door's hinge bolts after the adjustment.

      Torque:
      32.5 N*m  { 332 kgf*cm, 24 ft.*lbf }
    6. A01H11RE07
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 4 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

    7. A01H21S

      Using a T40 "TORX" socket, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.

    8. Using a T40 "TORX" socket, tighten the striker mounting screws after the adjustment.

      Torque:
      23 N*m  { 235 kgf*cm, 17 ft.*lbf }

    9. Connect the auxiliary battery negative (-) terminal cable to the battery.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    10. Check SRS warning light.