PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)
REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)
REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)
Detach the 2 clips and remove the deck trim side board LH.
REMOVE BATTERY SERVICE HOLE COVER LH
| *A | for Standard |
| *B | for Ottoman |
| *1 | Fastening Tape |
Detach the clip, fastening tape and remove the battery service hole cover LH.
DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE LUGGAGE COMPARTMENT DOOR ASSIST GRIP
| *1 | Protective Tape |
Using a screwdriver, detach the 3 claws.
Tech Tips
Tape the screwdriver tip before use.
Remove the 2 screws and luggage compartment door assist grip.
REMOVE SWITCH BEZEL
Using a screwdriver, detach the 2 claws and remove the switch bezel.
Tech Tips
Tape the screwdriver tip before use.
REMOVE NO. 2 COURTESY LIGHT ASSEMBLY
| *1 | Protective Tape |
Using a screwdriver, detach the 2 claws and remove the No. 2 courtesy light assembly.
Tech Tips
Tape the screwdriver tip before use.
REMOVE REAR COMBINATION LIGHT SERVICE COVER LH
Detach the 2 claws and remove the rear combination light service cover LH.
REMOVE REAR COMBINATION LIGHT SERVICE COVER RH
Tech Tips
Use the same procedure described for the LH side.
REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER LH
Using a clip remover, remove the 3 clips and luggage compartment door hinge cover LH.
REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH
REMOVE BACK DOOR TRIM COVER
Using a clip remover, remove the 4 clips.
Detach the 10 clips and back door trim cover.
REMOVE LUGGAGE DOOR CLOSER ASSEMBLY
Disconnect the connector.
Remove the 3 bolts and luggage door closer assembly.
Disconnect the cable.