POWER TRUNK LID SYSTEM, Diagnostic DTC:B2250

DTC Code DTC Name
B2250 Back Door Closer Operation Malfunction

DESCRIPTION


DTC Code DTC Detection Condition Trouble Area
B2250 When position information is incorrect due to malfunction in closer motor position switch, courtesy switch, or pawl switch of luggage compartment door closer

  • Luggage compartment door closer

  • Harness or connector

  • Luggage closer motor (power trunk lid ECU)

WIRING DIAGRAM

Refer to "Luggage Compartment Door Closer does not Operate" Click here.

INSPECTION PROCEDURE

PROCEDURE


  1. READ VALUE USING GTS (LUGGAGE COMPARTMENT DOOR CLOSER)


    1. Check the Data List for proper functioning of the luggage compartment door closer Click here.

      Back Door:
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Close Motor Pos1 Closer motor position switch signal / ON or OFF

      ON: Closer motor position switch is ON

      OFF: Closer motor position switch is OFF

      		 -
      Pawl Position SW Pawl switch signal / ON or OFF

      ON: Pawl switch is ON

      OFF: Pawl switch is OFF

      		 -
      Courtesy SW Courtesy switch signal / ON or OFF

      ON: Courtesy switch is ON

      OFF: Courtesy switch is OFF

      		 -
      OK
      On GTS screen, each item changes between ON and OFF as shown in above chart.

    NG

    CHECK HARNESS AND CONNECTOR (LUGGAGE COMPARTMENT DOOR CLOSER - LUGGAGE CLOSER MOTOR) Click here

    OK

    REPLACE LUGGAGE CLOSER MOTOR ASSEMBLY Click here

  2. CHECK HARNESS AND CONNECTOR (LUGGAGE COMPARTMENT DOOR CLOSER - LUGGAGE CLOSER MOTOR)

    A01GZ8IE05

    1. Disconnect the S43 motor connector.

    2. Disconnect the S36 closer connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      S43-24 (LOPN) - S36-2 (OPN) Always Below 1 Ω
      S43-20 (PAWL) - S36-5 (CLS) Always Below 1 Ω
      S43-22 (LCTY) - S36-7 (CTY) Always Below 1 Ω
      S36-8 (E) - Body ground Always Below 1 Ω
      S36-2 (OPN) - Body ground Always 10 kΩ or higher
      S36-5 (CLS) - Body ground Always 10 kΩ or higher
      S36-7 (CTY) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. REPLACE LUGGAGE COMPARTMENT DOOR CLOSER ASSEMBLY


    1. Temporarily replace the luggage compartment door closer with a new or normally functioning one Click here.


    NEXT

  4. CLEAR DTC


    1. Clear the DTC Click here.


    NEXT

  5. CHECK FOR DTC


    1. Recheck for DTCs Click here.

      OK
      DTC B2250 is not output.

    NG

    REPLACE LUGGAGE CLOSER MOTOR ASSEMBLY Click here

    OK

    END (LUGGAGE COMPARTMENT DOOR CLOSER IS DEFECTIVE)