SEAT HEATER SWITCH (for Fixed Seat Type) REMOVAL


  1. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY


    1. A01GXB4E01
      Text in Illustration
      *A w/ Seat Heater System

      Detach the 3 front hooks of the bench type rear seat cushion assembly from the vehicle body.

      Note

      Follow the instructions below carefully as the cushion frame deforms easily.

    2. Choose a hook to detach first. Place your hands near the hook. Then lift the bench type rear seat cushion assembly to detach the hook.

    3. Repeat the step above for the other hook.

    4. Detach the 2 rear hooks of the bench type rear seat cushion assembly from the bench type rear seatback assembly.

    5. w/ Seat Heater System:

      Disconnect the 2 connectors.

    6. Remove the bench type rear seat cushion assembly.

      Note

      Be careful not to damage the vehicle body.

  2. REMOVE BENCH TYPE REAR SEATBACK ASSEMBLY


    1. A01H1P1

      Remove the 2 bolts and nut to disconnect the 3 belt anchors of the rear seat 3 point type belt assembly LH, rear seat 3 point type belt assembly RH and rear center seat outer belt assembly.

    2. A01H0KUE04
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 2 claws to open the 2 caps of the rear seat shoulder belt guide.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure to open the 2 caps on the other side.

    3. Disconnect the rear seat outer belt from the rear seat shoulder belt guide.

      Tech Tips

      Use the same procedure to disconnect the rear seat outer belt on the other side.

    4. Lower the rear center armrest assembly.

    5. A01GWGA

      Lower the rear center seat headrest assembly.

    6. A01GZT1E04

      Detach the 2 clips. Then detach the hook by lowering the rear seat armrest hole board, and remove it.

    7. A01GZ6J

      w/ Seat Heater System:


      1. Remove the bolt and pull out the junction block.

      2. Disconnect the connector.

    8. A01GWRJE02

      Remove the 4 bolts and nut.

    9. Lift the bench type rear seatback assembly to detach the 2 hooks.

    10. Disconnect the rear center armrest assembly connector to remove the bench type rear seatback assembly.

      Note

      Be careful not to damage the vehicle body.

  3. REMOVE REAR SEAT CENTER ARMREST ASSEMBLY


    1. A01GXYVE01

      Detach the wire harness clamp.

    2. Remove the 2 nuts and rear seat center armrest assembly.

  4. REMOVE REAR NO. 1 SEAT CENTER ARMREST PANEL


    1. A01GW9ZE01

      Using moulding remover A, detach the 8 claws and 3 guides to remove the rear No. 1 seat center armrest panel together with the rear seat armrest hole board as indicated by the arrows in the order shown in the illustration.

    2. Disconnect the 2 connectors.

    3. A01H0QD

      Remove the 3 screws and rear No. 1 seat center armrest panel from the rear seat armrest hole board.

  5. REMOVE REAR POWER SEAT SWITCH


    1. A01GWNC

      Remove the 4 screws and rear power seat switch.