FRONT POWER SEAT CONTROL SYSTEM Front Power Seat does not Operate with Front Power Seat Switch

DESCRIPTION

When a signal is input into the front power seat switch (seat ECU), the ECU manages the signals received from the front power seat switch LH and RH, and operates each motor. When 2 or more signals are input, the motors only operate when the signals are from the slide switch and reclining switch.

INSPECTION PROCEDURE

PROCEDURE

1. Click here

   INSPECT FUSE

   
   

   1. Remove the D P/SEAT and D MPX-B 1 fuses from the main body ECU.

   2. Remove the P P/SEAT 1 and P MPX-B fuses from the passenger side junction block.

   3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition D P/SEAT fuse Always Below 1 Ω D MPX-B 1 fuse Always Below 1 Ω P P/SEAT 1 fuse Always Below 1 Ω P MPX-B fuse Always Below 1 Ω

   
   
   • OKClick here
   • NGClick here
2. Click here

   CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT SWITCH - BATTERY AND BODY GROUND)

   
   
   1. 

      for Driver side:

      
      

      1. Disconnect the e45*1, e46*1, e78*2 and e79*2 switch connectors.

      2. Measure the voltage according to the value(s) in the table below.

         Standard voltage
         for LHD
         Tester Connection Condition Specified Condition e45-7 (+B) - Body ground Always 11 to 14 V e46-4 (SYSB) - Body ground Always 11 to 14 V
         for RHD
         Tester Connection Condition Specified Condition e78-7 (+B) - Body ground Always 11 to 14 V e79-4 (SYSB) - Body ground Always 11 to 14 V

      3. Measure the resistance according to the value(s) in the table below.

         Standard resistance
         for LHD
         Tester Connection Condition Specified Condition e45-6 (GND) - Body ground Always Below 1 Ω
         for RHD
         Tester Connection Condition Specified Condition e78-6 (GND) - Body ground Always Below 1 Ω

   2. 

      for Passenger side:

      
      

      1. Disconnect the e18*1, e20*1, e71*2 and e72*2 switch connectors.

      2. Measure the voltage according to the value(s) in the table below.

         Standard voltage
         for LHD
         Tester Connection Condition Specified Condition e18-7 (+B) - Body ground Always 11 to 14 V e20-4 (SYSB) - Body ground Always 11 to 14 V
         for RHD
         Tester Connection Condition Specified Condition e71-7 (+B) - Body ground Always 11 to 14 V e72-4 (SYSB) - Body ground Always 11 to 14 V

      3. Measure the resistance according to the value(s) in the table below.

         Standard resistance
         for LHD
         Tester Connection Condition Specified Condition e18-6 (GND) - Body ground Always Below 1 Ω
         for RHD
         Tester Connection Condition Specified Condition e71-6 (GND) - Body ground Always Below 1 Ω

   
   
   • OKClick here
   • NGClick here
3. Click here

   REPLACE FRONT POWER SEAT SWITCHClick here

4. Click here

   REPLACE FUSE

5. Click here

   REPAIR OR REPLACE HARNESS OR CONNECTOR