ULTRASONIC SENSOR (for Rear Side) REMOVAL

Note

When replacing the sensor, only replace the clips and sensor.


  1. REMOVE REAR BUMPER COVER

    Click here

  2. REMOVE NO. 3 LUGGAGE ROOM WIRE


    1. Disconnect the 4 connectors.

    2. Detach the 4 clamps and remove the No. 3 luggage room wire.

      A01H1CF
    3. A01GW2L

      Detach the 2 claws and remove the ultrasonic sensor clip.

      Tech Tips

      Use the same procedure to remove the ultrasonic sensor clip on the other side.

  3. REMOVE NO. 1 ULTRASONIC SENSOR


    1. A01H08G

      Remove the sensors from the 4 sensor retainers as shown in the illustration.

      Note


      • Be careful not to damage the retainer.

      • Do not forcibly remove the retainer from the bumper cover.

  4. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    1. A01GWDX

      While heating the retainer using a dryer, pull the retainer lightly and remove the double-sided tape. Then remove the retainer.

      Heating temperature
      40 to 60°C (104 to 140°F)

      CAUTION:

      Be careful of burns.

    2. Using a cloth or non-residue solvent, wipe off any tape residue on the bumper cover.