BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1ABB

DTC Code DTC Name
C1ABB Blind Spot Monitor Master Module Beam Axis Inspection Incomplete

DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.

Tech Tips

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.

DTC Code DTC Detection Condition Trouble Area
C1ABB A beam axis inspection has not been performed. Blind spot monitor sensor LH

INSPECTION PROCEDURE

PROCEDURE


  1. PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)


    1. Change the blind spot monitor sensor LH to Test Mode using the GTS.

      Tech Tips

      Refer to Blind Spot Monitor Beam Axis Inspection Click here.


    NEXT