LEXUS PARKING ASSIST-SENSOR SYSTEM No. 1 Clearance Warning Buzzer Circuit

DESCRIPTION

The clearance warning buzzer sounds to alert the driver and buzzer frequency changes depending on the distance to an obstacle.

WIRING DIAGRAM

A01GZF4E07

INSPECTION PROCEDURE

PROCEDURE


  1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER


    1. Select the ACTIVE TEST, use the intelligent tester to generate a control command, and then check that the buzzer operates.

      Clearance Sonar
      Tester Display Test Part Control Range Diagnostic Note
      Front Buzzer Front clearance warning buzzer Operate or Stop -
      OK
      Front clearance warning buzzer sounds.

    NG

    CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - FRONT CLEARANCE WARNING BUZZER) Click here

    OK

    PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Click here

  2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - FRONT CLEARANCE WARNING BUZZER)


    1. A01GXEUE05

      Disconnect the L159 ECU connector.

    2. Disconnect the L48 buzzer connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      L159-1 (CBZ) - L48-1 (Z+) Always Below 1 Ω
      L159-2 (EE) - L48-2 (Z-) Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK FRONT CLEARANCE WARNING BUZZER


    1. Temporarily replace the front clearance warning buzzer with a new or normally functioning one Click here.

    2. Check the clearance warning buzzer sounds.

      OK
      Front clearance warning buzzer sounds.

    NG

    REPLACE CLEARANCE WARNING ECU Click here

    OK

    END (FRONT CLEARANCE WARNING BUZZER IS DEFECTIVE)