NAVIGATION SYSTEM, Diagnostic DTC:B1568

DTC Code DTC Name
B1568 Clock Device Disconnected

DESCRIPTION

The clock assembly and multi-media module receiver assembly are connected by the AVC-LAN communication line.

When an AVC-LAN communication error occurs between the clock assembly and multi-media module receiver assembly, these DTCs will be stored.

DTC Code DTC Detection Condition Trouble Area
B1568 A device that is listed in the AVC-LAN connected device record of the master unit is missing.

  • Clock assembly

  • Accessory meter assembly

  • Harness or connector

Tech Tips

Even if no fault is present, this DTC may be stored depending on the auxiliary battery condition or hybrid control system start voltage.

WIRING DIAGRAM

A01GYJ0E07

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTCs Click here.


    NEXT

  2. CHECK DTC


    1. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      No DTCs are output.

    NG

    CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - BATTERY AND BODY GROUND) Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here

  3. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - BATTERY AND BODY GROUND)


    1. A01H1JGE06
      Text in Illustration
      *a

      Front view or wire harness connector

      (to Clock Assembly)

      Disconnect the clock assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L161-7 (E) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      L161-5 (B) - L161-7 (E) Power switch off 11 to 14 V
      L161-10 (ACC) - L161-7 (E) Power switch on (ACC) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - ACCESSORY METER ASSEMBLY)


    1. Disconnect the L161 clock assembly connector.

    2. Disconnect the L163 accessory meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L161-3 (TX+1) - L163-5 (TX2+) Always Below 1 Ω
      L161-2 (TX-1) - L163-17 (TX2-) Always Below 1 Ω
      L161-3 (TX+1) - Body ground Always 10 kΩ or higher
      L161-2 (TX-1) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  5. CHECK CLOCK ASSEMBLY


    1. Replace the clock assembly with a new or normally functioning one Click here.


    NEXT

  6. CLEAR DTC


    1. Clear the DTCs Click here.


    NEXT

  7. CHECK DTC


    1. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      No DTCs are output.

    NG

    REPLACE ACCESSORY METER ASSEMBLY Click here

    OK

    END (CLOCK ASSEMBLY IS DEFECTIVE)