Click here

REAR DOOR SPEAKER (for Standard Body) INSTALLATION

Click here
Click here Click here
Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here
  1. Click here

    INSTALL REAR NO. 3 SPEAKER ASSEMBLY (for 19 Speakers)

    Note:

    Do not touch the cone of the speaker.


    1. A01GXE5E01

      Align the rear No. 3 speaker assembly to the door position pins A.

    2. Install the rear No. 3 speaker assembly with the 2 screws.

    3. Attach the clamp and connect the connector.

  2. Click here

    INSTALL REAR NO. 2 SPEAKER ASSEMBLY (for 19 Speakers)

    Note:

    Do not touch the cone of the speaker.


    1. A01GZK1E01

      Temporarily install the speaker by attaching the claw of the speaker to the door panel.

    2. Install the rear No. 2 speaker assembly with the 3 screws.

      Tip:

      Install the screws in the order shown in the illustration.

    3. Connect the connector.

  3. Click here

    INSTALL REAR NO. 1 SPEAKER ASSEMBLY

    Note:

    Do not touch the cone of the speaker.


    1. Install the rear No. 1 speaker assembly and attach the clip.

    2. A01H226E03

      Install the 2 screws.

      Table 1. Text in Illustration
      *A for Standard *B for 19 Speakers

    3. Connect the connector.

  4. Click here

    INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH (w/ Rear Door Sunshade)


    1. for Long Body:


      1. A01GXAA

        Connect the 2 cables to the inside handle.

      2. Connect the connector.

      3. Install the rear door trim board sub-assembly LH with the 3 screws and 14 clips.

    2. for Standard Body:


      1. A01GXAA

        Connect the 2 cables to the inside handle.

      2. Connect the connector.

      3. Install the rear door trim board sub-assembly LH with the 3 screws and 12 clips.

  5. Click here

    INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. for Long Body:


      1. A01GXAA

        Connect the 2 cables to the inside handle.

      2. Connect the connector.

      3. Install the rear door trim board sub-assembly LH with the 3 screws and 13 clips.

    2. for Standard Body:


      1. A01GXAA

        Connect the 2 cables to the inside handle.

      2. Connect the connector.

      3. Install the rear door trim with the 3 screws and 11 clips.

  6. Click here

    INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    1. Install the illumination light with the screw.

    2. Connect the connector.

    3. Attach the 2 clips to install the rear power window regulator switch assembly with rear door armrest base panel.

  7. Click here

    INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    1. Attach the 3 claws to install the rear door inside handle bezel plug LH.