REAR PACKAGE TRAY SPEAKER REMOVAL


  1. PRECAUTION

    CAUTION:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    A01GWKI

  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    A01GZ3P

  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)


    1. A01GXQQ

      Detach the 2 clips and remove the deck trim side board LH.

  5. REMOVE BATTERY SERVICE HOLE COVER LH


    1. A01GZIME02
      Text in Illustration
      *A for Standard
      *B for Ottoman
      *1 Fastening Tape

      Detach the clip, fastening tape and remove the battery service hole cover LH.

  6. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE REAR SEAT ASSEMBLY


    1. for Power Seat:

      Click here

    2. for Ottoman Seat:

      Click here

    3. for Fixed Seat Type:

      Click here

  8. REMOVE REAR DOOR SCUFF PLATE LH


    1. for Standard Body:

      Click here

    2. for Long Body:

      Click here

  9. REMOVE REAR DOOR SCUFF PLATE RH


    1. for Standard Body:

      Click here

    2. for Long Body:

      Click here

  10. REMOVE REAR SEAT SIDE GARNISH LH

    A01GW72

    1. Detach the 6 claws and remove the rear seat side garnish LH.

  11. REMOVE REAR SEAT SIDE GARNISH RH

    Tech Tips

    Use the same procedure described for the LH side.

  12. REMOVE INNER ROOF SIDE GARNISH LH

    A01GW31E10
    Text in Illustration
    *1 Clip A

    1. Pull the inner roof side garnish LH away from the body to detach the 4 clips (do not detach clip A).

    2. Detach the 2 claws of the guide, and pull the inner roof side garnish LH in the direction of the arrow to remove it.

      Tech Tips

      Clip A remains attached to the body.

    3. Remove clip A from the vehicle body.

  13. REMOVE INNER ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure described for the LH side.

  14. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY


    1. A01GWDN

      except 4-Passenger with Ottoman:

      Using a moulding remover D, detach the 4 claws and remove the 3 belt guides.

    2. for 4-Passenger with Ottoman:

      Using a moulding remover D, detach the 4 claws and remove the 2 belt guides.

    3. A01GY1H

      except 4-Passenger with Ottoman:

      Detach the 2 clips of the package tray trim panel assembly. Then pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.

    4. A01H1AU

      for 4-Passenger with Ottoman:

      Detach the 2 clips of the package tray trim panel assembly. Then pass the 2 rear seat belt floor anchors through the package tray trim panel assembly.

    5. Disconnect the solar sensor connector and remove the package tray trim panel.

  15. REMOVE STEREO COMPONENT SPEAKER ASSEMBLY

    Note

    Do not touch the cone of the speaker.


    1. Disconnect the connector.

    2. Remove the 4 bolts and stereo component speaker assembly.

      A01GYRLE02
      Text in Illustration
      *A for Standard *B for 19 Speakers