Click here

RADIO RECEIVER INSTALLATION

Click here
Click here Click here
Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart (Click here).

Click here
  1. Click here

    INSTALL NO. 1 RADIO BRACKET


    1. Install the No. 1 radio bracket with the 3 bolts.

  2. Click here

    INSTALL NO. 2 RADIO BRACKET


    1. Install the No. 2 radio bracket with the 3 bolts.

  3. Click here

    INSTALL MULTI-MEDIA MODULE RECEIVER ASSEMBLY


    1. Connect the connectors.

    2. Insert the multi-media module receiver assembly with bracket.

      Note:

      When inserting the radio receiver, do not press the knobs on it.

    3. Attach the 6 clips.

    4. Install the multi-media module receiver assembly with bracket with the 2 bolts.

  4. Click here

    INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. Connect the connector.

    2. Attach the 5 guides and 4 clips to install the lower No. 1 instrument panel finish panel.

  5. Click here

    INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL


    1. Attach the 5 guides and 4 clips to install the lower No. 2 instrument panel finish panel.

  6. Click here

    INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. Attach the 6 clips to install the upper console panel sub-assembly.

    2. Connect the connector.

  7. Click here

    INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY


    1. Connect each connector and attach each wire harness clamp.

    2. Attach the 6 clips to install the upper rear console panel sub-assembly.

    3. Install the 2 screws.

  8. Click here

    INSTALL NO. 3 BOX PANEL


    1. Attach the 4 claws to install the No. 3 box panel.

  9. Click here

    INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    1. Twist the shift lever knob sub-assembly in the direction indicated by the arrow to install it.

  10. Click here

    INSTALL INSTRUMENT PANEL FINISH PANEL END LH


    1. Attach the rear part of the instrument panel finish panel end LH 3 clips.

    2. Attach the front part of the instrument panel finish panel end LH 6 clips to install the instrument panel finish panel end LH.

  11. Click here

    INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Tip:

    Use the same procedure described for the LH side.

  12. Click here

    CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  13. Click here

    INSTALL BATTERY SERVICE HOLE COVER LH


    1. A01GZIME02

      Attach the battery service hole cover LH with the clip and fastening tape.

      Table 1. Text in Illustration
      *A for Standard
      *B for Ottoman
  14. Click here

    INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)


    1. A01GXQQ

      Attach the 2 clips to install the deck trim side board LH.

  15. Click here

    INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

  16. Click here

    INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)