REAR SEAT ENTERTAINMENT SYSTEM Television Display Power Source Circuit

DESCRIPTION

This is power source circuit of the television display assembly.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - AUXILIARY BATTERY AND BODY GROUND)

   
   
   1. 

      Text in Illustration

      *A	for 4-Passenger with Ottoman
      *B	for 5-Passenger with Ottoman
      *C	except Ottoman
      *a	Front view of wire harness connector (to Television Display Assembly)

      Disconnect the television display assembly connector.

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for 4-Passenger with Ottoman, except Ottoman Tester Connection Condition Specified Condition R92-3 (GND) - Body ground Always Below 1 Ω R92-19 (GND2) - Body ground Always Below 1 Ω
      for 5-Passenger with Ottoman Tester Connection Condition Specified Condition R112-3 (GND) - Body ground Always Below 1 Ω R112-19 (GND2) - Body ground Always Below 1 Ω

   3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      for 4-Passenger with Ottoman, except Ottoman Tester Connection Condition Specified Condition R92-1 (+B) - Body ground Always 11 to 14 V R92-17 (+B2) - Body ground Always 11 to 14 V
      for 5-Passenger with Ottoman Tester Connection Condition Specified Condition R112-1 (+B) - Body ground Always 11 to 14 V R112-17 (+B2) - Body ground Always 11 to 14 V

   
   

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here