REAR SEAT ENTERTAINMENT SYSTEM Multi-display Controller Power Source Circuit

DESCRIPTION

This is the power source circuit of the disc player assembly.

WIRING DIAGRAM

A01GZ5KE05

INSPECTION PROCEDURE

Note

Inspect the fuses and relays for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (DISC PLAYER ASSEMBLY - AUXILIARY BATTERY AND BODY GROUND)


    1. A01GY19E08
      Text in Illustration
      *A for 4-Passenger with Ottoman
      *B for 5-Passenger with Ottoman
      *C except Ottoman
      *a

      Front view of wire harness connector

      (to Disc Player Assembly)

      Disconnect the disc player assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for 4-Passenger with Ottoman
      Tester Connection Condition Specified Condition
      z95-13 (GND) - Body ground Always Below 1 Ω
      for 5-Passenger with Ottoman, except Ottoman
      Tester Connection Condition Specified Condition
      R98-13 (GND) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      for 4-Passenger with Ottoman
      Tester Connection Condition Specified Condition
      z95-8 (+B) - Body ground Always 11 to 14 V
      z95-7 (ACC) - Body ground Power switch on (ACC) 11 to 14 V
      for 5-Passenger with Ottoman, except Ottoman
      Tester Connection Condition Specified Condition
      R98-8 (+B) - Body ground Always 11 to 14 V
      R98-7 (ACC) - Body ground Power switch on (ACC) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here