Tech Tips
Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
INSTALL FRONT AIRBAG SENSOR LH
Check that the power switch is off.
Check that the cable is disconnected from the battery negative (-) terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
Connect the connector.
Install the front airbag sensor LH with the 2 bolts.
Note
If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
Check that there is no looseness in the installation parts of the front airbag sensor.
INSTALL HEADLIGHT ASSEMBLY LH
CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL BATTERY SERVICE HOLE COVER LH
| *A | for Standard |
| *B | for Ottoman |
Attach the battery service hole cover LH with the clip and fastening tape.
INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)
Attach the 2 clips to install the deck trim side board LH.
INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)
CHECK SRS WARNING LIGHT