DESCRIPTION
The front airbag sensor LH consists of the diagnostic circuit and the frontal deceleration sensor, etc.
If the center airbag sensor assembly receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated.
DTC B1615/14 is recorded when a malfunction is detected in the front airbag sensor LH circuit.
| DTC Code | Detection Condition | Trouble Area |
|---|---|---|
| B1615/14 | Either condition is met:
|
|
WIRING DIAGRAM
INSPECTION PROCEDURE
Note
After turning the power switch OFF, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.
When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected Click here.
PROCEDURE
CHECK FRONT AIRBAG SENSOR LH
Turn the power switch OFF.
Disconnect the negative (-) terminal cable from the auxiliary battery, and wait for at least 90 seconds.
Interchange the front airbag sensor RH with LH and connect the connectors to them.
Connect the negative (-) terminal cable to the auxiliary battery, and wait for at least 2 seconds.
Turn the power switch ON (IG), and wait for at least 60 seconds.
Clear the DTCs stored in the memory Click here.
Turn the power switch OFF.
Turn the power switch ON (IG), and wait for at least 60 seconds.
Check for DTCs Click here.
| Result | Proceed to |
|---|---|
| DTC B1615 is output | A |
| DTC B1610 is output | B |
| DTC B1610 and B1615 are not output | C |
Tech Tips
Codes other than DTC B1610 and B1615 may be output at this time, but they are not related to this check.
| A |
|
REPLACE CENTER AIRBAG SENSOR ASSEMBLY Click here |
| B |
|
REPLACE FRONT AIRBAG SENSOR LH Click here |
| C |
|
USE SIMULATION METHOD TO CHECK Click here