Click here

AIR CONDITIONING AMPLIFIER INSTALLATION

Click here
Click here Click here
Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart (Click here).

Click here
  1. Click here

    INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY


    1. A01GY59E01

      Insert the protrusion part of the air conditioning amplifier assembly to the fitting point of the air conditioning unit, and then align the hole of the air conditioning unit assembly with the locating pin of the air conditioning unit and install the screw.

      Table 1. Text in Illustration
      *1 Protrusion Part
      *2 Fitting Point

    2. Connect the 3 connectors.

  2. Click here

    INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY


    1. Attach the 2 claws to install the No. 2 air duct sub-assembly.

    2. Install the screw.

  3. Click here

    INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    1. Connect each connector and attach each wire harness clamp.

    2. Install the glove compartment door assembly with the 5 screws <C>.

  4. Click here

    INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A01GYLT

      Push in the lock to connect the airbag connector.

    4. Connect the airbag connector to the front passenger side knee airbag assembly

      Note:

      When connecting airbag connector, take care not to damage the airbag wire harness.

    5. Attach the claw to install the front passenger side knee airbag assembly.

    6. Install the 3 bolts.

      10 N*m 102 kgf*cm 7 ft.*lbf
      Note:

      Confirm that the front passenger side knee airbag assembly is installed securely without any excessive gaps and is not protruding outward.

  5. Click here

    INSTALL LOWER INSTRUMENT PANEL


    1. Attach the 2 claws and clip to install the lower instrument panel.

  6. Click here

    INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Connect the connector.

    2. Insert the 2 guides.

    3. Attach the 4 claws to install the No. 2 instrument panel under cover sub-assembly.

  7. Click here

    INSTALL INSTRUMENT SIDE PANEL RH


    1. Attach the 6 clips to install the instrument side panel RH.

  8. Click here

    CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  9. Click here

    INSTALL BATTERY SERVICE HOLE COVER LH


    1. A01GZIME02

      Attach the battery service hole cover LH with the clip and fastening tape.

      Table 2. Text in Illustration
      *A for Standard
      *B for Ottoman
  10. Click here

    INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

  11. Click here

    INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

  12. Click here

    INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

  13. Click here

    CHECK SRS WARNING LIGHT

    (Click here)