AIR CONDITIONING PANEL INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL NO. 1 RADIO BRACKET


    1. Install the No. 1 radio bracket with the 3 bolts.

      Torque:
      2.4 N*m  { 24 kgf*cm, 21 in.*lbf }

  2. INSTALL NO. 2 RADIO BRACKET


    1. Install the No. 2 radio bracket with the 3 bolts.

      Torque:
      2.4 N*m  { 24 kgf*cm, 21 in.*lbf }

  3. INSTALL MULTI-MEDIA MODULE RECEIVER ASSEMBLY (AIR CONDITIONING PANEL)


    1. Connect the connectors.

    2. Attach the 6 clips to install the multi-media module receiver assembly (air conditioning panel).

    3. Install the 2 bolts.

  4. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. Connect the connector.

    2. Attach the 5 guides and 4 clips to install the lower No. 1 instrument panel finish panel.

  5. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL


    1. Attach the 5 guides and 4 clips to install the lower No. 2 instrument panel finish panel.

  6. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. Attach the 6 clips to install the upper console panel sub-assembly.

    2. Connect the connector.

  7. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY

    A01H1P8

    1. Connect each connector and attach each wire harness clamp.

    2. Attach the 6 clips to install the upper rear console panel sub-assembly.

    3. Install the 2 screws.

  8. INSTALL NO. 3 BOX PANEL


    1. Attach the 4 claws to install the No. 3 box panel.

  9. INSTALL UPPER INSTRUMENT CLUSTER FINISH PANEL


    1. Attach the 5 clips to install the upper instrument cluster finish panel.

  10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

    A01GZSN

    1. Twist the shift lever knob sub-assembly in the direction indicated by the arrow to install it.

  11. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


    1. Attach the rear part of the instrument panel finish panel end LH 3 clips.

    2. Attach the front part of the instrument panel finish panel end LH 6 clips to install the instrument panel finish panel end LH.

  12. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Tech Tips

    Use the same procedure described for the LH side.

  13. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  14. INSTALL BATTERY SERVICE HOLE COVER LH


    1. A01GZIME02
      Text in Illustration
      *A for Standard
      *B for Ottoman

      Attach the battery service hole cover LH with the clip and fastening tape.

  15. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)


    1. A01GXQQ

      Attach the 2 clips to install the deck trim side board LH.

  16. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    A01GZ3P

  17. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    A01GWKI