HEATER WATER PUMP REMOVAL


  1. REMOVE NO. 1 ENGINE UNDER COVER


    1. A01GYE9

      Remove the 13 screws, 7 clips and No. 1 engine under cover.

  2. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator reservoir cap and vent plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. Loosen the radiator drain cock plug.

      A01H1N0E01
      Text in Illustration
      *1 Radiator Reservoir *2 Radiator Reservoir Cap
      *3 Cylinder Block Drain Cock Plug *4 Vent Plug
      *5 No. 1 Radiator Hose *6 Radiator Drain Cock Plug

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    2. A01GX4HE02
      Text in Illustration
      *1 Vent Plug

      Remove the radiator reservoir cap, and using a 6 mm hexagon wrench, remove the vent plug.

    3. Drain the coolant.

    4. Loosen the 2 cylinder block drain cock plugs.

  3. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01GZ6XE01

      While using both hands, lift the rear side of the V-bank cover sub-assembly upwards to detach the 4 clips labeled B. Slide the V-bank cover sub-assembly towards the front of the vehicle to detach the 2 clips labeled A, and remove the V-bank cover sub-assembly.

      Note

      The V-bank cover sub-assembly may be damaged if its front and rear are lifted at the same time.

  4. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY


    1. A01GWDEE01

      Remove the 5 clips labeled A.

    2. Lift up the air cleaner inlet cover sub-assembly to detach the 4 clips labeled B, and remove the air cleaner inlet cover sub-assembly.

  5. REMOVE ENGINE ROOM SIDE COVER RH


    1. A01GWGRE01

      for LHD:

      Remove the 5 clips and engine room side cover RH.

      Note

      Remove the clip labeled A by turning it to prevent the engine room side cover RH and bracket from being damaged.

      Tech Tips

      The clip labeled A cannot be removed from the engine room side cover RH.

    2. A01H09J

      for RHD:

      Remove the 5 clips and engine room side cover RH.

  6. REMOVE NO. 1 AIR CLEANER INLET


    1. A01GY2C

      Remove the 2 bolts.

    2. A01H12BE01

      Hold the No. 1 air cleaner inlet by the protrusions labeled A and B, and detach the connections.

    3. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion labeled C.

    4. Hold the No. 1 air cleaner inlet by the protrusions labeled D and E, and detach the connections.

    5. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion labeled F.

  7. REMOVE RADIATOR RESERVOIR ASSEMBLY


    1. A01H135

      Disconnect the 2 reservoir hoses.

    2. Remove the 2 bolts and radiator reservoir assembly.

  8. REMOVE HEATER WATER PUMP ASSEMBLY


    1. A01H1DE

      Disconnect the 2 connectors from the oil pump driver ECU.

    2. A01H1OS

      Remove the 2 clips and disconnect the 2 water hoses.

    3. Disconnect the connector.

    4. Remove the 2 nuts and water pump.