STEERING GEAR INSPECTION


  1. INSPECT TOTAL PRELOAD


    1. A01GZ87E01

      Using SST and a torque wrench, inspect the preload.

      SST
      09616-00011
      Standard preload (turning)
      1.5 to 2.5 N*m (16 to 25 kgf*cm, 14 to 22 in.*lbf)

      If the turning torque is not as specified, replace the power steering link assembly.

  2. INSPECT TIE ROD ASSEMBLY LH


    1. Secure the tie rod LH in a vise.

    2. Install the nut to the stud bolt.

    3. Flip the ball joint back and forth 5 times or more.

    4. A01H02J

      Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

      Standard turning torque
      0.5 to 3.4 N*m (6 to 34 kgf*cm, 5 to 30 in.*lbf)

      If the turning torque is not as specified, replace the tie rod assembly LH.

  3. INSPECT TIE ROD ASSEMBLY RH

    Tech Tips

    Use the same procedures described for the LH side.