POWER STEERING SYSTEM, Diagnostic DTC:C1569

DTC Code DTC Name
C1569 Battery Power Supply Voltage Malfunction

DESCRIPTION

As a fail-safe function, when the battery power supply voltage is malfunctioning, power assistance is limited/stopped.

DTC Code Detection Condition Trouble Area
C1569 Malfunction in auxiliary battery power supply voltage.

  • EPS ECU fuse

  • Harness or connector

  • Power steering ECU

WIRING DIAGRAM

A01H020E01

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT FUSE (EPS ECU)


    1. Remove the EPS ECU fuse from the engine room No. 2 relay block.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      EPS ECU fuse Always Below 1 Ω

    NG

    REPLACE FUSE

    OK

  2. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND)


    1. A01H0VRE02

      Disconnect the A44 ECU connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition
      A44-6 (+B) - Body ground Always 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      A44-5 (PGND) - Body ground Always Below 1 Ω

      Note

      If replacing the power steering ECU, initialize the rotation angle sensor value and calibrate the torque sensor zero point Click here.


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE POWER STEERING ECU Click here