Click here

ELECTRIC PARKING BRAKE SYSTEM Electric Parking Brake AUTO Switch Light Circuit

Click here
Click here Click here
DTC Code DTC Name
  Electric Parking Brake AUTO Switch Light Circuit
Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

  • If the electric parking brake ECU or parking brake with bracket actuator assembly is replaced, perform the "RESET MEMORY" and "ACQUIRE TENSION SENSOR ZERO POINT" procedures (see pageClick here).

  • Even after the power switch is turned OFF, the electric parking brake ECU may store a DTC as a result of removing a connector or fuse, as the ECU is still operating. Therefore, during inspection or replacement, turn the power switch OFF and wait for 20 seconds before removing the following: 1) connectors of the electric parking brake ECU, and 2) fuses of the electric parking brake system circuit.

Tip:

This flowchart is the inspection method for when the AUTO switch light of the electric parking brake continuously illuminates.

Click here

PROCEDURE


  1. Click here

    CHECK AUTO SWITCH (DATA LIST)


    1. Turn the power switch OFF.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the power switch ON (IG) and the tester ON.

    4. Enter the following menus: Chassis / Electric Parking Brake / Data List.

    5. Check the values by referring to the table below.

      Table 1. Electric Parking Brake
      Tester Display Measurement Item/ Range Normal Condition Diagnostic Note
      AUTO Switch

      AUTO switch input information display/

      ON or OFF

      ON: AUTO switch is pressed and held

      OFF: AUTO switch OFF (released)

      		 -
      Table 2. Result
      Result Proceed to
      Tester screen does not display ON even though AUTO switch is pressed A
      Tester screen displays ON while pressing AUTO switch B

  2. Click here

    INSPECT ELECTRIC PARKING BRAKE SWITCH (AUTO SWITCH)


    1. Remove the electric parking brake switch (see pageClick here).

    2. A01H12PE03

      Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Switch Condition Specified Condition
      5 (AUTO) - 8 (GND) AUTO switch is pressed and held Below 1 Ω
      AUTO switch OFF (released) 1 MΩ or higher

  3. Click here

    CHECK HARNESS AND CONNECTOR (ECU - SWITCH)


    1. Disconnect the S48 ECU connector.

    2. Disconnect the L39 switch connector.

    3. A01GYB2E06

      Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      S48- 5 (AUTO) - L39-5 (AUTO) Always Below 5 Ω
      S48- 5 (AUTO) - Body ground Always 100 kΩ or higher

  4. Click here

    CHECK HARNESS AND CONNECTOR (ECU - SWITCH)


    1. Disconnect the S46 ECU connector.

    2. Disconnect the L39 switch connector.

    3. A01GZQQE02

      Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      S46-6 (LPA) - L39-3 (IND-) Always Below 5 Ω
      S46-6 (LPA) - Body ground Always 100 kΩ or higher

  5. Click here

    REPLACE ELECTRIC PARKING BRAKE SWITCHClick here

  6. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  7. Click here

    REPLACE ELECTRIC PARKING BRAKE ECUClick here