BRAKE PEDAL SUPPORT (for LHD) INSTALLATION

Note

While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
1. Text in Illustration
  
  *1 Brake Pedal Support
  
  Install the brake pedal support with the 2 bolts.
  
  Torque:
  
  19 N*m { 195 kgf*cm, 14 ft.*lbf }
2. Install the 4 nuts.
  
  Torque:
  
  13 N*m { 130 kgf*cm, 9 ft.*lbf }

Text in Illustration
*1	Brake Pedal Support

INSTALL PUSH ROD PIN

Text in Illustration
*1	Push Rod Pin
*2	Clip
*3	Push Rod Clevis
*4	Lithium soap base glycol grease

Apply a light coat of lithium soap base glycol grease to the push rod pin.

Set the master cylinder push rod clevis in place, insert the push rod pin from outside of the vehicle and then install a new clip.

INSTALL BRAKE PEDAL RETURN SPRING
1. Install the spring between the pedal and steering column.
CONNECT CONNECTORS
1. Connect the stop light switch connector and then attach the wire harness clamp.
2. Connect the brake pedal stroke sensor connector.
CHECK BRAKE DRAG
CHECK AND ADJUST BRAKE PEDAL

Click here
INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here
CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL BATTERY SERVICE HOLE COVER LH
1. Text in Illustration
  
  *A for Standard
  
  *B for Ottoman
  
  Attach the battery service hole cover LH with the clip and fastening tape.
INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)
1. Attach the 2 clips to install the deck trim side board LH.
INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)
CHECK SRS WARNING LIGHT

Click here

Text in Illustration
*A	for Standard
*B	for Ottoman