BRAKE PEDAL SUPPORT (for LHD) REMOVAL

Note

While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

PRECAUTION

CAUTION:

Be sure to read the Precaution thoroughly before servicing Click here.

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)
REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)
REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)
1. Detach the 2 clips and remove the deck trim side board LH.

REMOVE BATTERY SERVICE HOLE COVER LH

Text in Illustration
*A	for Standard
*B	for Ottoman
*1	Fastening Tape

Detach the clip, fastening tape and remove the battery service hole cover LH.

DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here
DISCONNECT CONNECTORS
1. Disconnect the brake pedal stroke sensor connector.
2. Disconnect the stop light switch connector, and then detach the wire harness clamp.
REMOVE BRAKE PEDAL RETURN SPRING
1. Remove the spring.
REMOVE PUSH ROD PIN
1. Text in Illustration
  
  *1 Push Rod Pin
  
  *2 Clip
  
  Remove the clip and push rod pin.
REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
1. Remove the 4 nuts.
2. Text in Illustration
  
  *1 Brake Pedal Support
  
  Remove the 2 bolts and brake pedal support.

Text in Illustration
*1	Push Rod Pin
*2	Clip