ELECTRICAL KEY OSCILLATOR (for Outside Luggage Compartment) REMOVAL


  1. REMOVE REAR BUMPER PLATE LH

    A01GYXNE01
    Text in Illustration
    *1 Protective Tape

    1. Using a screwdriver, detach the 3 claws and remove the upper rear bumper cover.

      Tech Tips

      Tape the screwdriver tip before use.

  2. REMOVE REAR BUMPER PLATE RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. REMOVE REAR BUMPER COVER

    A01GWCM

    1. Remove the screw, and then remove the rear bumper seal bracket.

      Tech Tips

      Use the same procedure for both screws and rear bumper seal brackets.

    2. Remove the 2 screws.

    3. Put protective tape around the rear bumper cover.

    4. Using a clip remover, remove the 6 clips.

    5. A01GZDO

      Remove the 2 screws.

    6. Detach the 14 claws and 4 guides.

    7. Disconnect the No. 3 luggage room wire connector.

    8. Remove the rear bumper cover.

      A01GXLBE01
      Text in Illustration
      *1 Protective Tape - -

  4. REMOVE REAR BUMPER ENERGY ABSORBER

    A01H0VX

    1. Remove the rear bumper energy absorber.

  5. REMOVE ELECTRICAL KEY ANTENNA

    A01GX3J

    1. Disconnect the connector.

    2. Remove the 2 nuts and electrical key antenna.