TIRE PRESSURE WARNING RESET SWITCH REMOVAL

Tech Tips


  • Use the same procedure for the RHD and LHD models.

  • The procedure listed below is for the LHD model.


  1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01GYFZ

    1. Remove the 2 screws.

    2. Detach the 2 claws as shown in the illustration and remove the No. 1 instrument panel under cover sub-assembly.

    3. Detach the 2 claws and disconnect the DLC3.

    4. Disconnect each connector and detach each wire harness clamp.

  2. REMOVE TIRE PRESSURE WARNING RESET SWITCH


    1. Disconnect the connector.

    2. A01H1GT

      Detach the 2 claws and remove the tire pressure warning reset switch from the No. 1 instrument panel under cover sub-assembly.