TIRE PRESSURE WARNING RECEIVER INSTALLATION

Tech Tips


  • Use the same procedure for the RHD and LHD models.

  • The procedure listed below is for the LHD model.


  1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER


    1. Install the tire pressure warning ECU and receiver with the bolt.

      Torque:
      for Black Bolt
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }
      for Silver Bolt
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note

      The torque value differs depending on whether the bolt is silver or black.

    2. Connect the connector.

  2. INSTALL TELEMATICS TRANSCEIVER

    Click here

  3. CONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL BATTERY SERVICE HOLE COVER LH


    1. A01GZIME02
      Text in Illustration
      *A for Standard
      *B for Ottoman

      Attach the battery service hole cover LH with the clip and fastening tape.

  5. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)


    1. A01GXQQ

      Attach the 2 clips to install the deck trim side board LH.

  6. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    A01GZ3P

  7. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    A01GWKI

  8. REGISTRATION OF TRANSMITTER ID

    Click here

  9. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

  10. PERFORM INITIALIZATION

    Click here