HEIGHT CONTROL SENSOR (for Rear LH) INSTALLATION

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.


  1. INSTALL LOAD SENSING VALVE SENSOR BRACKET LH


    1. Install the bracket to the toe control link with the bolt.

  2. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. A01GXVR

      Install the height control sensor with the 2 bolts.

      Torque:
      14 N*m  { 138 kgf*cm, 10 ft.*lbf }

      Note

      Do not drop the height control sensor. If it is dropped, replace it with a new one.

    2. A01GYBJE03

      Align the matchmarks on the height control sensor link and bracket.

    3. Install the nut to the height control sensor link.

      Torque:
      5.3 N*m  { 54 kgf*cm, 47 in.*lbf }

    4. Connect the connector.

  3. CHECK VEHICLE HEIGHT

    Note

    If the height control sensor link is removed, check the vehicle height.


    1. Change the height control switch from the "NORMAL" position to the "HEIGHT HIGH" position and back to the "NORMAL" position again.

    2. Measure the vehicle height Click here.

  4. ADJUST VEHICLE HEIGHT

    Click here

    Note

    If the height control sensor has been replaced, be sure to adjust the vehicle height.

  5. ADJUST HEADLIGHT ASSEMBLY

    Click here

  6. ADJUST OBJECT RECOGNITION CAMERA

    Click here