ACTIVE STABILIZER SUSPENSION SYSTEM, Diagnostic DTC:C194F, C1950, C1951

DTC Code DTC Name
C194F Operation of Static Test Mode is Incomplete (Test Mode DTC)
C1950 Front Stabilizer Target Angle Not Attained (Test Mode DTC)
C1951 Rear Stabilizer Target Angle Not Attained (Test Mode DTC)

DESCRIPTION

If the Active Test does not operate, test mode DTCs C194F and C1950 are output for the front, and C194F and C1951 are output for the rear. If system malfunction DTCs are already stored, test mode DTCs are not stored. During the Active Test, if the power switch is turned OFF or an actuator is malfunctioning, test mode DTCs are stored due to incompletion of operation. If this occurs, turn the power switch OFF (unless already turned OFF) and turn the power switch ON (READY). Then perform the Active Test to complete the operation normally, and the test mode DTC will be erased.

DTC Code Detection Condition Trouble Area
C194F Active Test incomplete Perform Active Test again
C1950 During Active Test, front malfunction occurs

  • Perform Active Test again

  • Front active stabilizer control ECU

  • Front active stabilizer control actuator
C1951 During Active Test, rear malfunction occurs

  • Perform Active Test again

  • Rear active stabilizer control ECU

  • Rear active stabilizer control actuator

INSPECTION PROCEDURE

PROCEDURE


  1. PERFORM ACTIVE TEST (FRONT AND/OR REAR ACTIVE STABILIZER)


    1. Turn the power switch OFF.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the power switch ON (READY) and the tester ON.

    4. Perform the Active Test Click here.

    5. After the Active Test ends, check that test mode DTCs are erased.

      Tech Tips

      If the Active Test cannot be performed, turn the power switch OFF and ON (READY) again, and perform the Active Test. If the Active Test still cannot be performed, there may be a system malfunction.

      Result
      Result Proceed to
      Even if Active Test is repeatedly attempted, Active Test cannot be performed (test mode DTC C194F and/or C1950 are output) A
      Even if Active Test is repeatedly attempted, Active Test cannot be performed (test mode DTC C194F and/or C1951 are output) B
      Active Test operates and test mode DTCs are not output C

    B

    GO TO FLOWCHART OF DTC C1901 Click here

    C

    END

    A

    GO TO FLOWCHART OF DTC C1929 Click here