SUSPENSION CONTROL RELAY ON-VEHICLE INSPECTION

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

REMOVE BATTERY SERVICE HOLE COVER LH

Text in Illustration
*A	for Standard
*B	for Ottoman
*1	Fastening Tape

Detach the clip, fastening tape and remove the battery service hole cover LH.

DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE SUSPENSION CONTROL RELAY (AIR SUS)
1. Remove the suspension control relay from the engine room No. 5 relay block.

INSPECT SUSPENSION CONTROL RELAY

Measure the resistance according to the value(s) in the table below.

Standard resistance

Tester Connection	Condition	Specified Condition
3 - 5	When battery voltage is not applied to terminals 1 and 2	10 kΩ or higher
3 - 5	When battery voltage is applied to terminals 1 and 2	Below 1 Ω

If the result is not as specified, replace the suspension control relay.

INSTALL SUSPENSION CONTROL RELAY
CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL BATTERY SERVICE HOLE COVER LH
1. Text in Illustration
  
  *A for Standard
  
  *B for Ottoman
  
  Attach the battery service hole cover LH with the clip and fastening tape.
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
CHECK SRS WARNING LIGHT

Click here