Click here

ACTIVE STABILIZER SUSPENSION SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Click here
Click here Click here
Tip:

  • Use these procedures to troubleshoot the active stabilizer suspension system.

  • *: Using the intelligent tester.


  1. Click here

    VEHICLE BROUGHT TO WORKSHOP


    • NEXT
  2. Click here

    INSPECT AUXILIARY BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.


    • NEXT
  3. Click here

    CHECK FOR DTC (ALL)*


    1. Check for all DTCs.

      Table 1. Result
      Result Proceed to
      DTC is output. A
      CAN communication system DTC is output. (for LHD) B
      CAN communication system DTC is output. (for RHD) C
      DTC is not output. D

      If a CAN communication malfunction code is output, troubleshoot that code before performing repairs on this system.


      • B
      • GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (see pageClick here)
      • C
      • GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (see pageClick here)
      • D
      • USE SIMULATION METHOD TO CHECK (see pageClick here)
      • A
  4. Click here

    REPAIR OR REPLACE


    1. Before performing repairs or replacement, refer to PRECAUTION (see pageClick here).

    2. Refer to the DIAGNOSTIC TROUBLE CODE CHART and perform repairs (see pageClick here).


      • NEXT
  5. Click here

    CONFIRMATION TEST*


    1. Perform the OPERATION CHECK (see pageClick here).


      • NEXT
      • END