REAR AXLE HUB ON-VEHICLE INSPECTION


  1. REMOVE REAR WHEEL

  2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH


    1. A01GY2Z

      Remove the 2 bolts and disconnect the rear disc brake caliper assembly.

      Note


      • Hang the caliper with wire or equivalent.

      • Do not damage the brake hose.

  3. REMOVE REAR DISC


    1. A01H1V9E03
      Text in Illustration
      *a Matchmark

      Put matchmarks on the rear disc and axle hub if planning to reuse the disc.

    2. A01GZZI

      Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  4. INSPECT REAR AXLE HUB BEARING LOOSENESS


    1. A01GXER

      Using a dial indicator, check for looseness near the center of the axle hub.

      Maximum
      0.05 mm (0.0020 in.)

      Note

      Ensure that the dial indicator is set at a right angle to the measurement surface.

      If the looseness exceeds the maximum, replace the axle hub.

  5. INSPECT REAR AXLE HUB RUNOUT


    1. A01H1DP

      Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

      Maximum
      0.05 mm (0.0020 in.)

      Note

      Ensure that the dial indicator is set at a right angle to the measurement surface.

      If the runout exceeds the maximum, replace the axle hub.

  6. INSTALL REAR DISC

    A01H0L7E01

    Note

    The disc has an identification mark. Make sure of the identification mark when installing the disc.

    Item Identification Mark
    LH L
    RH R

    1. A01H1V9E03
      Text in Illustration
      *a Matchmark

      While aligning the matchmarks, install the rear disc.

      Tech Tips

      When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.

  7. ADJUST PARKING BRAKE SHOE CLEARANCE


    1. Adjust parking brake shoe clearance Click here.

      Note

      If the parking brake shoe clearance is not adjusted, the cable end may be damaged.

  8. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH


    1. A01GY2Z

      Connect the rear disc brake caliper assembly LH with new 2 bolts.

      Torque:
      86 N*m  { 877 kgf*cm, 63 ft.*lbf }

      Note


      • Do not twist the flexible hose.

      • Make sure the screw parts are free from foreign matter and are not damaged.

      • Be careful not to overtighten the bolts, as the rear axle carrier is made of aluminum.

  9. INSTALL REAR WHEEL

    Torque:
    140 N*m  { 1428 kgf*cm, 103 ft.*lbf }