DIFFERENTIAL CARRIER ASSEMBLY REMOVAL


  1. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

    Click here

  2. REMOVE DRIVE SHAFT ASSEMBLY

    Click here

  3. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY


    1. Support the rear differential carrier assembly with a transmission jack.

      CAUTION:


      • As the rear differential carrier assembly is very heavy, securely support it with a transmission jack.

      • Perform this procedure with several people supporting the rear differential carrier assembly so that it does not tilt or fall.

    2. A01H14FE01

      Using SST or a 12 mm socket hexagon wrench, remove the 3 bolts (A) from the rear No. 1 and No. 2 differential mount cushions.

      SST
      09961-00950

    3. Remove the 2 bolts (B).

    4. Slowly lower the transmission jack. Then remove the rear differential mount stopper upper and lower, and rear differential carrier assembly from the rear suspension member.

      Note


      • Do not drop the rear differential carrier assembly.

      • When removing the rear differential carrier assembly, do not damage the installation surface.