FRONT PROPELLER SHAFT ASSEMBLY INSTALLATION

TEMPORARILY INSTALL FRONT PROPELLER SHAFT ASSEMBLY

1. Completely remove any oil or the like and clean the constant velocity universal joint washers and the contact surfaces of the front propeller shaft assembly, transfer and front differential.

2. 

   Align the matchmarks on the differential companion flange and front propeller shaft.

   Table 1. Text in Illustration

   *a

   Matchmark

3. Temporarily install the front propeller shaft with 6 new bolts and the 2 universal joint washers.

4. 

   Align the matchmarks on the transfer companion flange and front propeller shaft.

   Table 2. Text in Illustration

   *a

   Matchmark

5. Temporarily install the front propeller shaft with 6 new bolts and the 2 universal joint washers.

INSTALL REAR ENGINE MOUNTING MEMBER

1. Set the rear No. 3 engine mounting insulator to the rear engine mounting member.

2. 

   Temporarily install the rear engine mounting member to the hybrid vehicle transmission assembly with the 5 nuts.

3. 

   Install the rear engine mounting member with the 4 bolts.

   35 N*m

   354 kgf*cm

   26 ft.*lbf

4. 

   Tighten the 5 nuts.

   38 N*m

   387 kgf*cm

   29 ft.*lbf

TIGHTEN FRONT PROPELLER SHAFT ASSEMBLY

1. Using a 6 mm socket hexagon wrench, tighten the front propeller shaft with the 6 bolts.

   25 N*m

   255 kgf*cm

   18 ft.*lbf

   Note:

   Be careful not to damage the front propeller shaft.

2. Using a 6 mm socket hexagon wrench, tighten the front propeller shaft with the 6 bolts.

   25 N*m

   255 kgf*cm

   18 ft.*lbf

   Note:

   Be careful not to damage the front propeller shaft.

INSTALL FRONT EXHAUST PIPE ASSEMBLY

(Click here)