PROPELLER SHAFT ASSEMBLY REASSEMBLY


  1. INSTALL NO. 1 CENTER SUPPORT BEARING ASSEMBLY

    Note

    Be careful not to grip the propeller shaft tube too tightly in a vise as this may cause deformation.


    1. A01H0RAE07
      Text in Illustration
      *a Turn
      *b Hold

      Using SST, install a new No. 1 dust deflector.

      SST
      09316-60011   ( 09316-00011 )
      09506-35010
      09950-40011   ( 09951-04020, 09952-04010, 09953-04030, 09954-04030, 09955-04021, 09958-04011 )

      Note

      Be careful not to damage the dust deflector.

    2. A01GWQGE07
      Text in Illustration
      *a Turn
      *b Hold

      Using SST, install the No. 1 center support bearing assembly.

      SST
      09330-50010
      09950-00020
      09950-40011   ( 09951-04020, 09953-04030 )
      09950-50013   ( 09952-05010, 09955-05040 )

      Note

      Be sure to install the bearing in the correct direction.

    3. A01H1QDE06
      Text in Illustration
      *a Turn
      *b Hold

      Using SST, insert a new No. 2 dust deflector until it almost touches the rubber of the No. 1 center support bearing assembly.

      SST
      09330-50010
      09950-00020
      09950-40011   ( 09951-04020, 09953-04030 )
      09950-50013   ( 09952-05010, 09955-05040 )

      Note

      Be careful not to damage the No. 2 dust deflector.

    4. A01GXE4

      Using a snap ring expander, install a new snap ring.

  2. INSTALL PROPELLER INTERMEDIATE SHAFT


    1. A01GZQWE08
      Text in Illustration
      *1 Protective Tape

      Install the dust boot.

      Note

      Assemble the propeller intermediate shaft assembly after wrapping protective tape around the spline so that it will not damage the boot.

    2. Apply grease to the spline.

      Grease
      Molybdenum disulphide lithium base NLGI No. 2

    3. Align the matchmarks and assemble the intermediate shaft and propeller shaft.

    4. A01GXN8E11
      Text in Illustration
      *1 Intermediate Shaft Assembly
      *2 Propeller Shaft Assembly
      *a Matchmark

      Cover the adjusting nut with the dust boot.

      Note

      The directions of the intermediate shaft companion flange and the propeller shaft companion flange should differ by 180°.

    5. Temporarily tighten the adjusting nut by hand.