TRANSFER OIL ON-VEHICLE INSPECTION


  1. CHECK TRANSFER OIL

    A01GXOA

    1. Using a 10 mm hexagon wrench, remove the filler plug and gasket.

    2. A01H1Z1E02
      Text in Illustration
      *a 0 to 5.0 mm (0 to 0.196 in.)

      Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.

      If the result is not as specified, add transfer oil.

      Note


      • Too much or too little oil will lead to transfer problems.

      • Keep the vehicle level during inspection.

    3. If addition of transfer oil is necessary, perform the following procedures.


      1. Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the case plug (for filler) hole.

        Oil grade
        Toyota Genuine Transfer gear oil LL 80 or equivalent
        Standard capacity
        0.7 liters (0.7 US qts, 0.6 Imp. qts)

    4. When the oil level is too low, check for an oil leak.

    5. Install a new gasket into the filler plug and then install the plug with a 10 mm hexagon wrench.

      Torque:
      49 N*m  { 500 kgf*cm, 36 ft.*lbf }