SHIFT LEVER INSPECTION

Tech Tips

Depending on the specifications of the vehicle, the shift lever will have an "S" or "M" position. The following inspection procedure refers to this position as the "S" shift lever position.


  1. INSPECT TRANSMISSION CONTROL SWITCH


    1. A01GWA6E18
      Text in Illustration
      *a

      Component without harness connected

      (Transmission Control Switch)

      Measure the resistance between each terminal of the shift lock control unit assembly when the shift lever is moved to each position.

      Standard resistance
      Tester Connection Shift Lever Position Specified Condition
      3 (IG) - 7 (S) Shift lever in S, "+" or "-" Below 1 Ω
      2 (SFTU) - 5 (E)

      Shift lever held in "+"

      (Up shift)

      		 Below 1 Ω
      1 (SFTD) - 5 (E)

      Shift lever held in "-"

      (Down shift)

      		 Below 1 Ω
      3 (IG) - 7 (S) Shift lever not in S, "+" or "-" 10 kΩ or higher
      2 (SFTU) - 5 (E) Shift lever in S 10 kΩ or higher
      1 (SFTD) - 5 (E) Shift lever in S 10 kΩ or higher

      If the resistance is not as specified, replace the transmission floor shift assembly.