SHIFT LEVER REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    A01GWKI

  2. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    A01GZ3P

  3. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)


    1. A01GXQQ

      Detach the 2 clips and remove the deck trim side board LH.

  4. REMOVE BATTERY SERVICE HOLE COVER LH


    1. A01GZIME02
      Text in Illustration
      *A for Standard
      *B for Ottoman
      *1 Fastening Tape

      Detach the clip, fastening tape and remove the battery service hole cover LH.

  5. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here

  6. DISCONNECT CABLE FROM AUXILIARY NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    1. A01GZB0

      Using a small screwdriver, detach the 2 claws and remove the shift lock release button cover.

      Tech Tips

      Tape the screwdriver tip before use.

    2. Depress the shift lock release button and move the shift lever to the N position.

    3. A01GYMY

      Remove the nut and disconnect the floor shift gear shifting rod sub-assembly from the connecting rod swivel.

  8. REMOVE CONSOLE BOX ASSEMBLY

    for 5-passenger with Ottoman: Click here

    w/o Rear Seat Entertainment System: Click here

    w/ DVD player: Click here

  9. REMOVE NO. 1 CONSOLE BOX DUCT


    1. A01H1Z2

      Disconnect the 2 wire harness clamps from the No. 1 console box duct.

    2. Remove the 2 clips and pull out the No. 1 console duct.

  10. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY


    1. A01GYPD

      for LHD:

      Disconnect the 2 connectors and 7 wire harness clamps from the transmission floor shift assembly.

    2. A01H24I

      for RHD:

      Disconnect the 3 connectors and 6 wire harness clamps from the transmission floor shift assembly.

    3. Remove the 4 bolts and transmission floor shift assembly.