HYBRID CONTROL SYSTEM, Diagnostic DTC:P0C2C-888, P0C2C-889

DTC Code DTC Name
P0C2C-888 Auxiliary Transmission Fluid Pump Control Module Feedback Signal Range / Performance
P0C2C-889 Auxiliary Transmission Fluid Pump Control Module Feedback Signal Range / Performance

DESCRIPTION

Refer to the description for DTC P0C29-865 Click here.

DTC No. INF Code DTC Detection Condition Trouble Area
P0C2C 888 The hybrid vehicle control ECU receives signals that indicate a malfunction (OPST cycle error or noise) in the oil pump motor controller. Oil pump motor controller
P0C2C 889 The hybrid vehicle control ECU receives signals that indicate a malfunction (OPST duty error) in the oil pump motor controller.

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HYBRID VEHICLE CONTROL ECU (CHECK WAVEFORM)


    1. A01GWFOE02

      Connect an oscilloscope between the hybrid vehicle control ECU terminals specified in the table below, and measure the waveform.

      Item Contents
      Terminal A76-33(OPST) - A77-7(E1)
      Equipment Setting 5 V/DIV., 5 ms./DIV.
      Condition Power switch on (IG)
      Result
      Result Proceed to
      There are no interruptions or distortions in the waveform. (Amount of noise is small.) A
      There is an interruption or distortion in the waveform. (Amount of noise is large.) B

    B

    CLEAR NOISE CONDITIONS

    A

  2. CHECK CONNECTOR CONNECTION CONDITION (OIL PUMP MOTOR CONTROLLER CONNECTOR)

    Note

    Before disconnecting the connectors, confirm that they are properly connected by checking that the locking claws are engaged and that the connectors do not pull out.


    1. A01H1EDE01

      Check the connections of the oil pump motor controller connectors.

      OK
      The connectors are connected securely and there are no contact problems.

      Tech Tips

      For connector A, when connecting it, insert it with the locking lever in the raised position. Rotate the lever downward and make sure that the connector is pulled into its socket. When the locking lever is in its fully closed position, a click will be heard as its locking claws engage. After the click is heard, pull up on the connector to confirm that it is properly connected.


    NG

    CONNECT SECURELY

    OK

  3. CHECK CONNECTOR CONNECTION CONDITION (HYBRID VEHICLE CONTROL ECU CONNECTOR)


    1. A01GW3PE01

      Check the connections of the hybrid vehicle control ECU connectors.

      OK
      The connectors are connected securely and there are no contact problems.

    NG

    CONNECT SECURELY

    OK

    REPLACE OIL PUMP MOTOR CONTROLLER Click here