OIL LEVEL SENSOR REMOVAL


  1. REMOVE FRONT CENTER FLOOR COVER (w/ Cover)


    1. A01GYNV

      Remove the 3 screws, 2 bolts, clip and front center floor cover.

  2. REMOVE NO. 2 ENGINE UNDER COVER


    1. A01H1Z8

      Remove the 4 screws, 2 clips and No. 2 engine under cover.

  3. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH


    1. A01H0ML

      Remove the 5 screws and front wheel opening extension pad LH.

  4. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. REMOVE NO. 1 ENGINE UNDER COVER


    1. A01GYE9

      Remove the 13 screws, 7 clips and No. 1 engine under cover.

  6. REMOVE FRONT LOWER SUSPENSION MEMBER PROTECTOR


    1. A01H26P

      Remove the 9 bolts and front lower suspension member protector.

  7. DRAIN ENGINE OIL


    1. A01H1PG

      Open the oil filler cap service hole cover.

    2. Remove the oil filler cap.

    3. Remove the oil pan drain plug and gasket, and drain the engine oil into a container.

    4. Install a new gasket and the oil pan drain plug.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

  8. REMOVE ENGINE OIL LEVEL SENSOR


    1. A01GW4D

      Disconnect the engine oil level sensor connector.

    2. Remove the 4 bolts.

    3. A01GYY5

      Rotate the engine oil level sensor 180° and remove it.

    4. A01GWDJE02

      Cut off the gasket as shown in the illustration.

    5. Remove the gasket from the oil level sensor.

      Tech Tips

      After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.