INTAKE AIR CONTROL VALVE ACTUATOR INSTALLATION


  1. INSTALL INTAKE AIR CONTROL VALVE ACTUATOR

    A01H0CW

    1. Temporarily install the actuator rod to the intake air control valve actuator.

    2. Install the intake air control valve actuator to the intake manifold with the 2 bolts.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    3. Install the actuator rod to the intake air control valve actuator with the nut.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Note

      When tightening the nut, hold the actuator rod in place so that it does not move.

    4. Connect the intake air control valve actuator connector.

  2. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A01GZ6XE01

      After sliding the V-bank cover sub-assembly from the vehicle front to the rear to attach the 2 clips labeled A, attach the 4 clips labeled B and install the V-bank cover sub-assembly.

      CAUTION:


      • Make sure the clips are attached securely.

      • Attaching the clips forcefully or hitting the top of the clips may damage them.